网站标志
商品搜索
点评详情
点评详情
发布于:2019-3-27 16:48:02  访问:42 次 回复:0 篇
版主管理 | 推荐 | 删除 | 删除并扣分
Soldering Iron
The dark spot is oil remaining through the cutting and forming process at the manufacture. If this oil is kept you will burn off your fitting and it surely will maybe not just take the solder.
Flux the pipe and fittings: making use of your flux past brush each end of this pipe and fixtures. This can guarantee a clean and joint that is tinned.
Time for you to solder: Whatever size your pipe, that is how solder that is much will have to used to sweat your bones together. Therefore, if you should be soldering 1" one inch copper pipe you will need one inch of solder to sweat your joints together.
Employing a torch heat your pipe and suitable evenly. Begin two ins behind the fitting and gradually warm your pipeline and fitting with a straight back and motion that is forth sweeping. Ensure your flame is near enough to cover the whole diameter of this pipe.
When your flame turns green apply the solder to your hub regarding the fitting, ensuring the solder moves all the real way around the hub. Wait!There is certainly one more "Secret" step to a perfect solder joint, this means the essential difference between an amateurish glob of a mess in your fittings or a professional looking solder joint every time.
To learn about soldering iron and stand and soldering iron equipment, please go to all of our website soldering iron ace hardware (relevant website).
You will find usually two forms of material used to construct a multilayer board. Pre-preg material is slim layers of fiberglass pre-impregnated by having an adhesive, and is in sheet type, frequently about .002 inches dense. Core product is similar to a very double that is thin board for the reason that it has a dielectric material, such as epoxy fiberglass, by having a copper layer deposited on each side, often .030 Thickness material that is dielectric 1 ounce copper layer on each side. In a board that is multilayer, there are two methods used to build up the required range levels. The core stack-up technique, which can be an adult technology, runs on the center layer of pre-preg material with a layer of core material above and another layer of core material below. This mixture of one pre-preg layer and two core levels would make a 4 layer board.
The film stack-up technique, a more recent technology, might have core product while the center layer accompanied by layers of pre-preg and copper material developed above and below to create the final wide range of levels needed by the board design, sort of love Dagwood creating a sandwich. This technique allows the maker freedom in the way the board layer thicknesses are combined to meet up with the product that is finished requirements by varying how many sheets of pre-preg in each layer. When the product levels are completed, the complete stack is put through temperature and pressure that triggers the adhesive in the pre-preg to bond the core and pre-preg layers together as a single entity.
共0篇回复 每页10篇 页次:1/1
共0篇回复 每页10篇 页次:1/1
我要回复
回复内容
验 证 码
看不清?更换一张
匿名发表 
脚注信息
Copyright (C) 2009-2010 All Rights Reserved. 极速时时彩官网  版权所有   沪ICP备01234567号
服务时间:周一至周日 08:30 — 20:00  全国订购及服务热线:021-98765432 
联系地址:上海市某某路某大厦20楼B座2008室   邮政编码:210000